No products in the cart.
Dimensions: With Dimensions of 12 inches by 40 feet this product allows you to easily cover and protect multiple boat trailer bunks boat trailer guides jet ski bunks and boat trailer runners. Heavy Duty Boat Bunk Carpeting: 20 oz. is thick enough to cushion but not too thick to retain water allowing boat bunks to dry faster and last longer. Made just like the carpet on your boat. Carpet uses are bunk padding boat carpet boat trailer bunks marine carpet for boats bunk rail carpet outdoor deck carpet outdoor porch carpet. Application: Can be glued or stapled. Use Arrow staple gun or air staple gun. Easy straight foward application. Durable: Our 20 oz. blue bunk carpet is designed to be thick and durable ensuring it can withstand the rigors of boat trailer use. The U/V resistant material helps prevent fading and damage caused by sun exposure allowing for a better looking trailer bunk for a longer period of time. Exhibits no water retention and withstands the effects of weathering. Rubber Backing: The rubber backing provides an extra layer of protection and grip for your boat bunk. With this added protection you can have peace of mind knowing that your boat and trailer are well-cushioned and protected against potential damage. Why trust Carpet by the Foote Our boat bunk carpet is made in the U.S.A. Marine Trailer Bunk Carpet can be used for just about any indoor/outdoor application. Quality discount carpet that is rubber backed fade resistant and ravel resistant. Can be glued or stapled down. Perfect for making boat and ski trailer bunks or guides. Durable easy to handle and install. Made in the U.S.A. Instructions for bunk making: 1-Unbolt and remove existing bunk boards from trailer. Take the existing bunk carpet off and sand away any glue or debris before applying new carpet. Examine the old bunk boards for damage. Replace if needed. 2-Measure the size of your boat bunks to determine the amount of bunk carpet you will need. This will help preserve your bunk carpet 4-Before carpeting your trailer bunks take the bolts used to secure your bunks to your trailer and insert them into your already drilled out holes on your bunk board. 5-Unroll and layout your new carpet which you have already cut to size with the rubber backing facing up. Place the bunk board evenly right to the edge of the laid out carpet. Leaving enough carpet on either end to completely wrap each end of your bunk. Hold the carpet to the board and start to roll the new carpet onto the bunk board. Staple down the first side. Then roll the board until it is completely covered. When you get to this point take a staple gun and apply staples every 2 to 3 inches along the bottom of the bunk board. This will ensure a secure and snug fit. If measured correctly when cut there should be about 2 inches or so of carpet left to overlap the first initial bottom side staple down this excess carpet on top of the existing carpet. 6-Take the newly wrapped bunk board and place it with the bottom side up one last time and use the excess carpet you have already accounted for at either end and wrap securing with glue or staples. Overlap and secure the excess carpet to the bottom side of the bunk. 7-Repeat steps for remaining bunks