No products in the cart.
A Reliable Wireless Driveway Alarm Made in the USA! Wireless driveway alarms like the Di2000S-A TXRX2000A will keep you informed and safe by alerting you when a car person or animal enters your driveway or any area you want to monitor. The system sends an alert to a receiver the RX2000A when the passive infrared motion sensor detector is triggered. These are just a few reasons this wireless driveway alarm has been and continues to be our number-one selling monitoring system. Although this is a best-in-class system to monitor your driveway it has many uses beyond that. The Plugin Receiver in this Kit: The receiver Di2000R-A or RX2000A supplied in the kit plugs into a standard wall outlet. On the back of the receiver is a volume control knob that allows you to adjust the volume according to your preference. Also on the back of the receiver/speaker are two-terminal screws; one powers an external speaker allowing you to hear the chime sound in another room or location. The second terminal screw is for a live 12-volt output which can power various accessories such as strobe lights sirens counters X10 interfaces and virtually any product powered by 12 volts. The receiver plays four 4 different sounds. An unlimited number of sensors the Di2000T-A TX2000A can be programmed into the receiver. Each programmed sensor will instruct the receiver to play one of the four available sounds. A series of dip switches labeled 1-6 are on the back of the receiver. Dip switches 1-4 must match the corresponding dip switches on the transmitter/sensor programmed to the receiver. The receiver has four terminal screws on the back powering 12V DC devices and a speaker. The 12V DC output can be used for buzzers strobe lights etc. The output duration may be set to 5 seconds or 20 seconds. The speaker will play the selected sound for the sensor/transmitter that triggers it. Scroll down the page to hear the sounds played by the receiver. The four sounds are set using the dip switch settings below: -Ding Dong 5 Off 6 OFF -Single Ding 5 ON 6 OFF -Double Ding Dong 5 OFF 6 ON -Turbo Sound 5 ON 6 ON The Transmitter in this Kit The transmitter/sensor in this kit is the TX2000A Di2000T-A by Rodann Electronics. When a car passes through the monitored zone the sensor sends a wireless signal up to 1000 ft. away to the plugin receiver shown above. The transmitter is a passive infrared sensor designed for outdoor use. It is powered by 2 x AA Alkaline batteries not included. To insert batteries remove the two screws on the back of the cover inside screw wells. On the circuit board of the sensor/transmitter is a jumper setting where you can adjust the sensitivity of the transmitter. It is set to normal by default with a jumper on pins A and B. For higher move the jumper to pins B and C. For low sensitivity remove the jumper save for future use. How to Position the Transmitter/Sensor Ideally using the included aluminum mounting bracket you should mount the sensor approximately 3-4 high on a non-metallic post. Point the antenna down to avoid moisture to keep moisture out–this will not affect functionality. The invisible passive infrared beam shoots out to approximately 50′. At 25′ the detection area is approximately 1’x1′ and at 50′ is 2’x2′. The TXRX2000A Driveway Informer Kit is Expandable Each RX2000A Di2000R-A can work with four different TX2000A Di2000T-A sensors. There is no limit to the number of receivers a transmitter/sensor can work with. Hear the RX2000A Sounds
- Ding Dong 5 Off 6 OFF.
- Single Ding 5 ON 6 OFF.
- Double Ding Dong 5 OFF 6 ON.
- Turbo Sound 5 ON 6 ON The Transmitter in this Kit The transmitter/sensor in this kit is the TX2000A Di2000T-A by Rodann Electronics.