No products in the cart.
HOBBYWING EZRUN MAX5 HV G2-56118SD G2 COMBO | Lipo Cells:6-12S Lipo | Sensored mode enhanced performance The Max5 HV G2 ESC is designed to work in full-sensored mode at all times when it is paired with HOBBYWING EzRun 56118 SD G2. The maximum output current of the ESC is as high as 250A. The stable output power together with an excellent low-speed linearity ensures the ESC meets various application requirements such as; hard launches straight-line high-speed jumps low speed crawling etc. Intelligent freewheeling technology strong drive low temperatures The innovative intelligent freewheeling technology effectively reduces heat generation and enables the ESC to have higher driving efficiency. At the same time operating temperature is drastically lowered to improve overall stability and reliability of the ESC. High protection level all-weather operation The IP-67 waterproof rating guarantees excellent waterproofing and dustproof protection. The whole power system is able to drive on a variety of surfaces including mud sand ice snow and water without damaging the power unit. 1/5th scale power system Turbo timing technology The ESC is able to support up to 24 degrees of Turbo Timing adjustment. There is an approximate of 18% increase in performance and is recommended to pair with the new HOBBYWING EzRun 56118 SD G2 motors to get the best performance. Powerful BEC The ESC has a built-in super BEC with a maximum output current of up to 25A. The output voltages are switchable between 6V/7.4V/8.4V. This ensures that the ESC is able to support the demanding high-torque servos in the market. Perfect combination with EzRun 56118 SD G2 motor Achieve the perfect compatibility when used together with EzRun 56118 SD G2 motors. Avoid damaging the motor from overheating with the software protection function. Record and store data in real time to keep track of the running status Connect the ESC to the OTA Bluetooth module and through the mobile phone APP you are able to view real-time data and operating status such as; throttle voltage current temperature speed etc. New sensor wire interface upgraded waterproof protection The new sensor wire interface enhances the ESC protection level and solves waterproof problems faced by traditional interfaces. Before using this product read the instruction manual carefully. Ensure that the equipment is used appropriately to avoid damaging the ESC. The wrong usage will overheat and damage the electronics. It is important to ensure that all wires soldered are properly secured to avoid short circuits from happening. A good soldering station is recommended to do such a job to avoid overheating the circuit board as well as to ensure connections are properly soldered. Even though the product has relevant protective measures always use it in a safe manner in accordance with the operating environment noted in the manual e.g voltage current temperature and etc. Always remember to disconnect the battery each time after using it. Failure to do so will cause the battery to be completely discharged resulting in an unpredictable danger.