Awaiting product image

Single-Phase to 3-Phase Converter My-PS-3 Model Must Be Only used on 2HP1.5kW 6 Amps 200-240V 3-Phase Motor One DPS Must Be used on One Motor

$48.68

Single-Phase to 3-Phase Converter My-PS-3 Model Must Be Only used on 2HP1.5kW 6 Amps 200-240V 3-Phase Motor One DPS Must Be used on One Motor

$48.68

DPS can run 3-phase motor with single-phase Very easy to connect DPS and motor Small size light weight Doesnt make any high frequency/Lower power consumption Keeps out dust moisture and heat due to the sealed type Digital Type Phase Converter/ Excellent start-up torque Efficiency is excellent versus others phase converters Low failure rate/Designed to be non-flammable Before purchasing a DPS be sure to check that the DPS model is compatible with your motor specifications. 1. 2. Do not use a DPS model that is not suitable for your motor specifications. Please check the voltageV rated currentA and horsepowerHP of the motor and select a DPS by referring to the DPS model selection table. In special cases be sure to consult with the manufacturer and seller. 3. One DPS must be used for one motor only. 4. Input/output voltage of DPS is 200V-240V. 5. The voltage of the motor should be 200V-240V. 6. The efficiency is around 90% when using a DPS model that matches the electric motor specifications. 7. The thickness of wires should be suitable for current. 8. DPS does not operate on 3-phase motor installed with 3-phase brake. DPS only works on 3-phase motor installed with a single-phase brake. 9. You can check 3-phase on the output of DPS when your motor is running. If your motor is not running you cant check the 3-phase from the output of DPS. 10. If a magnetic contactor is connected to the motor and DPS you must connect two control wires of the magnetic contactor to ‘U’and ‘W’of the DPS output. If the motor does not work even though the power is turned on after connecting the DPS and the motor please try swapping the positions of wires connected to ‘U ‘V and ‘W’of the DPS output at least 3 times. 11. When the motor load is less than 50% there may be an imbalance from the voltages and currents output from the DPS. Normally when the motor load is over 50% voltages and currents will be balanced.

  • This item should be used at 2HP motor1.5KW 6 amps
  • Drive 3 phase motor220V with 1 phase Rated Voltage:3 phase 220V 10%
  • The failure rate is remarkably low
  • Excellent start-up torque / The size is small easy to install
  • Semi-permanent life time