No products in the cart.
Even a v-6 with a maximum power of 300 horsepower won’t be a problem to lift at full throttle. The hydraulic actuator is housed within the power structure lift however it may be accessed without removing the engine. There are no hoses to deal with and unlike other transom jacks you won’t have to worry about placing a pump and reservoir inside your boat. With its own fluid reservoir the hydraulic actuator is totally self-contained eliminates the need for a hydraulic tank and hoses inside the boat. It has a wiper and a no-leak seal to keep dirt and water out of the operating sections. The system is built entirely of non-ferrous metals. It is thus immune to both saltwater and freshwater. Because of the innovative roller design there is less friction longer wear and virtually no binding issues which are prevalent with other transom jacks. A stainless steel 3/4 inch pin and aluminum-bronze alloy rollers make up the roller assembly. The roller is highly impact-resistant corrosive resistant and capable of carrying a large load. This innovative design essentially avoids binding which is a typical problem with other transom jacks.
- Full stroke in 8 seconds.
- Made of 6061 T6 alloy aluminum extrusions and fastened with stainless steel fasteners.
- Ideal for fresh or salt water use.
- No welds or castings to break.
- The dependable self-contained and waterproof hydraulic actuator has a maximum lifting capacity of 7853 pounds of thrust.
- A total of 8″ of possible adjustment.