No products in the cart.
SCC010010050R -The Victron MPPT controller will adjust its input voltage to harvest the maximum power from the solar array and then transform this power to supply the varying voltage requirement of the battery plus load. Thus it essentially decouples the array and battery voltages so that there can be for example a 12 volt battery on one side of the MPPT charge controller and a large number of cells wired in series to produce 36 volts on the other. To fully exploit the potential of the MPPT controller the array voltage should be substantially higher than the battery voltage. The MPPT controller is the solution of choice for higher power systems because of the lowest overall system cost due to smaller cable cross sectional areas. It will also harvest substantially more power when the solar cell temperature is low below 45 C or very high above 75 C or when irradiance is very low.
- Type: Charger
- Amperage: 10 A
- Multicolour
- Material: Plastic
- Recommended use: Unisex adult